l own a '95 Infiniti G20 and purchased a keyless entry remote for it a few months back. l purchased directions for programming but have been unsuccessful. l do not wanna take it to a dealer because they wanna charge me $60 for programming. Anyone know what to do? How l could get it to work?
These are the directions l got.
Get in the car lock the doors and open the trunk. Insert key into ignition 6-8 times until hazards flash. Then press the unlock button on the remote.

You have to follow the directions to a T. If you are replacing a broken remote, their might be other problems, like the receiver. You have to turn the Key On and Off so many times, with in a some many seconds. l had a Ford Focus, that was the same way.

NOTE: A maximum of 4 remote transmitters can be programmed.

Obtain all remote transmitters.
Open the trunk.
Close & lock all doors.
Insert & remove key from the ignition switch more than 6 times within 10 seconds.
All original remote codes r now erased.
Unlock then lock vehicle using the driver is door LOCK/UNLOCK lever.
Press LOCK button on first remote transmitter to be programmed.
First remote transmitter now programmed.
To program next remote transmitter:
Unlock then lock vehicle using the driver is door LOCK/UNLOCK lever.
Press LOCK button on second remote transmitter to be programmed.
Repeat above procedure to program remaining remote transmitter.
To exit programming mode: Open driver is or passenger is door.
Check operation of all programmed remote transmitters.